Over 15 years experience of providing support of MEAN WELL Power Supplies
Overview
ODLC-45-700 is the model of this series: rated current 700mA, rated power 44.8W, typical efficiency 85%.
ODLC-45 series is a 45W LED AC/DC driver featuring the constant current mode output with flicker free design.ODLC-45 operates from 90~295VAC and offers models with different rated current ranging between 350mA and 1400mA. Thanks to the efficiency up to 86%, with the fanless design, the entire series is able to operate for -20℃~+85℃ case temperature under free convection. The design of plastic housing and IP67 ingress protection level allows this series to fit indoor wet applications. ODLC-45 is equipped with various function options, such as dimming methodologies, so as to provide the optimal design flexibility for lighting system.
Features
- Constant Current mode output
- Flicker free design
- Plastic housing with class II design
- Built-in active PFC function
- No load power consumption<0.5W(Blank-Type), Standby power consumption<0.5W(DA-Type)
- IP67 rating for indoor or outdoor installations
- Function options: 2 in 1 dimming (dim-to-off); Auxiliary DC output; DALI
- 3 years warranty
Specifications
OUTPUT
- RATED CURRENT
- 700mA
- RATED POWER
- 44.8W
- CONSTANT CURRENT REGIONNote.2
- 38 ~ 64V
- OPEN CIRCUIT VOLTAGE(max.)
- 84V
- CURRENT RIPPLE
- 5% max. @rated current
- CURRENT TOLERANCE
- ±7.0%
- SETUP TIMENote.4
- 500ms / 230VAC 1200ms/115VAC
- AUXILIARY DC OUTPUTNote.5
- Nominal 12V(deviation 11.4~12.6)@50mA for ODLC-45A only
INPUT
- VOLTAGE RANGENote.3
- 90 ~ 295VAC (Please refer to "STATIC CHARACTERISTIC" section)
- FREQUENCY RANGE
- 47 ~ 63Hz
- POWER FACTOR (Typ.)
- PF>0.95/115VAC, PF>0.92/230VAC, PF>0.9/277VAC@full load (Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section)
- TOTAL HARMONIC DISTORTION
- THD< 20%(@load≧60%/230VAC; @load≧75%/277VAC) (Please refer to “TOTAL HARMONIC DISTORTION” section)
- EFFICIENCY (Typ.)
- 85%
- AC CURRENT
- 0.6A/115VAC 0.4A/230VAC 0.3A/277VAC
- INRUSH CURRENT (Typ.)
- COLD START 30A(twidth=100μs measured at 50% Ipeak) at 230VAC; Per NEMA 410
- MAX. No. of PSUs on 16A CIRCUIT BREAKER
- 32 units (circuit breaker of type B) / 32 units (circuit breaker of type C) at 230VAC
- LEAKAGE CURRENT
- <0.75mA / 277VAC
- NO LOAD/STANDBY POWER CONSUMPTION
- No load power consumption<0.5W for Blank-Type,<1.2W for ODLC-45A Standby power consumption<0.5W for DA-Type
PROTECTION
- SHORT CIRCUIT
- Hiccup mode,auto-recovery after fault condition is removed for DA type; Hiccup mode,re-power on to recovery for other type
ENVIRONMENT
- WORKING TEMP.
- Tcase=-20 ~ +85℃ (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section)
- MAX. CASE TEMP.
- Tcase=+85℃
- WORKING HUMIDITY
- 20 ~ 90% RH non-condensing
- STORAGE TEMP., HUMIDITY
- -40 ~ +80℃, 10 ~ 95% RH
- TEMP. COEFFICIENT
- ±0.03%/℃ (0 ~ 40℃)
- VIBRATION
- 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY & EMC
- SAFETY STANDARDS
- UL8750(type”HL”),CSA C22.2 NO.250.13-12;ENEC BS EN/EN61347-1 & BS EN/EN61347-2-13 independent, BS EN/EN62384; BIS IS15885( for ODLC-45-700,1050,700DA,1050DA only), EAC TP TC 004,IP67 approved
- DALI STANDARDS
- Compliance to IEC62386-101, 102 for DA-Type only
- WITHSTAND VOLTAGE
- I/P-O/P:3.75KVAC
- ISOLATION RESISTANCE
- I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH
- EMC EMISSION
- Compliance to BS EN/EN55015, BS EN/EN61000-3-2 Class C (@load≧60%) ; BS EN/EN61000-3-3, GB17743,GB17625.1,EAC TP TC 020
- EMC IMMUNITY
- Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11; BS EN/EN61547, light industry level(surge immunity: Line-Line:1KV),EAC TP TC 020
OTHERS
- MTBF
- 3513.4K hrs min. Telcordia SR-332 (Bellcore) ;340.8K hrs min. MIL-HDBK-217F (25℃)
- DIMENSION
- 111*77*28.5mm(L*W*H)
- PACKING
- 0.42Kg; 24pcs/ 11Kg/ 0.72CUFT
Test conditions and notes10
- 1. All parameters NOT specially mentioned are measured at 230VAC input, rated current and 25℃ of ambient temperature.
- 2. Please refer to "DRIVING METHODS OF LED MODULE".
- 3. De-rating may be needed under low input voltages. Please refer to “STATIC CHARACTERISTIC” sections for details.
- 4. Length of set up time is measured at cold first start. Turning ON/OFF the driver may lead to increase of the set up time.
- 5. Aux. 12V will be damaged with short circuit; It will not be available when output voltage is not in constant current region or output no load condition.
- 6. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
- 7. The DALI version driver does not support the bit 1: Lamp failure in the Command 144 Query status of the DALI standard.
- 8. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).
- 9. For any application note and IP water proof function installation caution, please refer our user manual before using. https://www.meanwell.com/Upload/PDF/LED_EN.pdf
- 10. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED power supply can only be used behind a switch without permanently connected to the mains.
Technical drawings
Typical applications
- LED panel lighting
- LED flood lighting
- Indoor LED lighting
- Industrial lighting
Downloads
Certificates7
Test reports1
Catalogues1
FAQ
Can I use the ODLC-45-700 for a 700mA LED downlight engine?
Yes, if the LED engine is designed for 700mA constant current and its total forward voltage falls within 38-64V. This driver is rated for 44.8W, so the connected load needs to stay within that power level. It is not intended for constant voltage LED products.
Is this driver suitable for compact signage or illuminated panels using 700mA LEDs?
It can be suitable when the signage module or small LED array requires 700mA constant current input. The output voltage adjusts across 38-64V, and the number of LEDs depends on the forward voltage of each LED rather than a fixed count. That makes it a current-matched choice instead of a voltage-matched one.
Can the ODLC-45-700 power a small COB or multi-LED array?
Yes, for COBs or small LED arrays that are rated for 700mA constant current and operate inside the 38-64V CC range. The maximum output power is 44.8W, so the load must remain within that limit. This makes it more suitable for medium-voltage constant current arrays than high-voltage ones.
What makes an LED module compatible with this 700mA driver?
The LED module must be specified for 700mA constant current operation and fit within the 38-64V output window. The actual LED count varies with each LED's forward voltage, so compatibility cannot be determined by LED quantity alone. Constant voltage modules are not a match for this driver.
Can this driver handle indoor and outdoor exposure?
The ODLC-45-700 carries an IP67 waterproof rating, so it is intended for applications where that level of environmental sealing is needed. It also operates from -20°C to +85°C, which supports a broad range of installation conditions. Environmental fit should still be evaluated at the finished fixture level.
Payment & Security
Payment methods
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
Other ODLC-45 Models
9 other models| Model | Power | Voltage | Current | IP Rating | |
|---|---|---|---|---|---|
| Mean Well ODLC-45-700DA Power Supply 45W 700mA, DALI | 44.8W | 64V | 0.7A | IP67 | View |
| Mean Well ODLC-45-500DA Power Supply 45W 500mA, DALI | 45W | 90V | 0.5A | IP67 | View |
| Mean Well ODLC-45-500 Power Supply 45W 500mA, Dimmable | 45W | 90V | 0.5A | IP67 | View |
| Mean Well ODLC-45-350DA Power Supply 45W 350mA, DALI | 33.25W | 95V | 0.35A | IP67 | View |
| Mean Well ODLC-45-350 Power Supply 45W 350mA, Dimmable | 33.25W | 95V | 0.35A | IP67 | View |
| Mean Well ODLC-45-1400DA Power Supply 45W 1400mA, DALI | 44.8W | 32V | 1.4A | IP67 | View |
| Mean Well ODLC-45-1400 Power Supply 45W 1400mA, Dimmable | 44.8W | 32V | 1.4A | IP67 | View |
| Mean Well ODLC-45-1050DA Power Supply 45W 1050mA, DALI | 45.15W | 43V | 1.05A | IP67 | View |
| Mean Well ODLC-45-1050 Power Supply 45W 1050mA, Dimmable | 45.15W | 43V | 1.05A | IP67 | View |
Please log in to write a review.
Write a review
Reviews are checked before publishing. By submitting you confirm this is your genuine experience with this product.
Submitting your review…
It's published and now helps other buyers.
We're checking it and it'll appear shortly.
Please try again.






