Over 15 years experience of providing support of MEAN WELL Power Supplies
Overview
HRP-300-15 is the 15V output model of this series: rated current 22A, rated power 330W, typical efficiency 88%.
Features
- Universal AC input / Full range
- Built-in active PFC function, PF>0.95
- High efficiency up to 89%
- Withstand 300VAC surge input for 5 seconds
- Protections: Short circuit / Overload / Over voltage / Over temperature
- Built-in constant current limiting circuit
- 1U low profile 41mm
- Built-in cooling fan ON-OFF control
- Built-in DC OK signal
- Built-in remote sense function
- 5 years warranty
Specifications
OUTPUT
- DC VOLTAGE
- 15V
- RATED CURRENT
- 22A
- CURRENT RANGE
- 0 ~ 22A
- RATED POWER
- 330W
- RIPPLE & NOISE (max.)Note.2
- 150mVp-p
- VOLTAGE ADJ. RANGE
- 13.5 ~ 18V
- VOLTAGE TOLERANCENote.3
- ±1.0%
- LINE REGULATION
- ±0.3%
- LOAD REGULATION
- ±0.5%
- SETUP, RISE TIME
- 1000ms, 50ms/230VAC 2500ms, 50ms/115VAC at full load
- HOLD UP TIME (Typ.)
- 16ms/230VAC 16ms/115VAC at full load
INPUT
- VOLTAGE RANGENote.5
- 85 ~ 264VAC 120 ~ 370VDC
- FREQUENCY RANGE
- 47 ~ 63Hz
- POWER FACTOR (Typ.)
- PF>0.95/230VAC PF>0.99/115VAC at full load
- EFFICIENCY (Typ.)
- 88%
- AC CURRENT (Typ.)
- 3.5A/115VAC 1.8A/230VAC
- INRUSH CURRENT (Typ.)
- 35A/115VAC 70A/230VAC
- LEAKAGE CURRENT
- <1.2mA / 240VAC
PROTECTION
- OVERLOAD
- 105 ~ 135% rated output power Protection type : Constant current limiting, recovers automatically after fault condition is removed
- OVER VOLTAGE
- 18.8 ~ 21.8V Protection type : Shut down o/p voltage, re-power on to recover
- OVER TEMPERATURE
- Shut down o/p voltage, recovers automatically after temperature goes down
FUNCTION
- DC OK SIGNAL
- PSU turns on : 3.3 ~ 5.6V ; PSU turns off : 0 ~ 1V
- FAN CONTROL (Typ.)
- Load 35±15% or RTH2≧50℃ Fan on
ENVIRONMENT
- WORKING TEMP.
- -40 ~ +70℃ (Refer to "Derating Curve")
- WORKING HUMIDITY
- 20 ~ 90% RH non-condensing
- STORAGE TEMP., HUMIDITY
- -40 ~ +85℃, 10 ~ 95% RH
- TEMP. COEFFICIENT
- ±0.03%/℃ (0 ~ 50℃)
- VIBRATION
- 10 ~ 500Hz, 5G 10min./1cycle, 60min. each along X, Y, Z axes
SAFETY & EMC (Note 4)
- SAFETY STANDARDS
- UL62368-1, TUV BS EN/EN62368-1, EAC TP TC 004, AS/NZS 62368.1 approved
- WITHSTAND VOLTAGE
- I/P-O/P:3KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC
- ISOLATION RESISTANCE
- I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25℃/ 70% RH
- EMC EMISSION
- Compliance to BS EN/EN55032 (CISPR32) Class B, BS EN/EN61000-3-2,-3, EAC TP TC 020
- EMC IMMUNITY
- Compliance to BS EN/ EN61000-4-2,3,4,5,6,8,11, BS EN/ EN55035, BS EN/ EN61000-6-2, heavy industry level, EAC TP TC 020
OTHERS
- MTBF
- 1487.1K hrs min. Telcordia SR-332 (Bellcore) ; 200.4K hrs min. MIL-HDBK-217F (25℃)
- DIMENSION
- 199*105*41mm (L*W*H)
- PACKING
- 0.95Kg;15pcs/15.3Kg/0.83CUFT
Test conditions and notes6
- 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
- 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1μF & 47μF parallel capacitor.
- 3. Tolerance : includes set up tolerance, line regulation and load regulation.
- 4. The power supply is considered a component which will be installed into a final equipment. All the EMC tests are been executed by mounting the unit on a 360mm*360mm metal plate with 1mm of thickness. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to “EMI testing of component power supplies.” (as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf )
- 5. Derating may be needed under low input voltages. Please check the derating curve for more details.
- 6. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).
Technical drawings
Downloads
FAQ
Can I use the HRP-300-15 for a 15V industrial control load that needs higher current?
Yes, this model is a constant voltage 15V power supply rated for 22A and 330W. It fits 15V industrial or automation loads whose total demand stays within that rating.
Is the HRP-300-15 suitable for embedded or test bench equipment that runs on 15V DC?
It can be a fit for embedded or bench systems that require a regulated 15V constant voltage source and draw within 22A. The wide 85-264VAC input also makes it practical where the AC supply may vary across sites.
Can this 15V model power a 15V automation subsystem instead of a 12V or 24V supply?
Use it when the subsystem is specifically designed for 15V DC, because this unit outputs 15V constant voltage at up to 22A. It is not the interchangeable choice for 12V or 24V loads in the HRP family.
Would the HRP-300-15 work for a centralized 15V DC load in a control cabinet?
Yes, if the combined 15V load stays within 330W and 22A. Its compact 199.0 × 105.0 × 41.0 mm size and 0.95 kg weight can help where cabinet space is limited.
Is the HRP-300-15 meant for outdoor or harsh-temperature use?
The operating temperature range is -40°C to +70°C, with output derating at higher ambient temperatures per the derating curve. No IP rating is listed in the provided specs, so it is better suited to indoor or protected enclosure use rather than exposed outdoor locations.
How does the HRP-300-15 compare with the other HRP-300 voltage options?
Within the HRP-300 group, the listed options are HRP-300-3.3 at 198W, 3.3V, 60A; HRP-300-5 at 300W, 5V, 60A; HRP-300-7.5 at 300W, 7.5V, 40A; HRP-300-12 at 324W, 12V, 27A; HRP-300-15 at 330W, 15V, 22A; HRP-300-24 at 336W, 24V, 14A; HRP-300-36 at 324W, 36V, 9A; and HRP-300-48 at 336W, 48V, 7A. The main difference is the output voltage and resulting current and wattage rating for each version.
Payment & Security
Payment methods
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
Other HRP-300 Models
4 other models| Model | Power | Voltage | Current | |
|---|---|---|---|---|
| Mean Well HRP-300-7.5 Power Supply 300W 7.5V 40A | 300W | 7.5V | 40A | View |
| Mean Well HRP-300-5 Power Supply 300W 5V 60A | 300W | 5V | 60A | View |
| Mean Well HRP-300-48 Power Supply 336W 48V 7A | 336W | 48V | 7A | View |
| Mean Well HRP-300-36 Power Supply 324W 36V 9A | 324W | 36V | 9A | View |
Please log in to write a review.
Write a review
Reviews are checked before publishing. By submitting you confirm this is your genuine experience with this product.
Submitting your review…
It's published and now helps other buyers.
We're checking it and it'll appear shortly.
Please try again.







