Over 15 years experience of providing support of MEAN WELL Power Supplies
Mean Well RS-15-3.3 Power Supply 15W 3.3V 3A
4.8 (14 reviews)Overview
RS-15-3.3 is the 3.3V output model of this series: rated current 3A, rated power 9.9W, typical efficiency 72%.
Features
- Universal AC input / Full range
- Protections: Short circuit / Overload / Over voltage / Over temperature
- Cooling by free air convection
- LED indicator for power on
- 100% full load burn-in test
- No load power consumption<0.5W
- All using 105β long life electrolytic capacitors
- Withstand 300VAC surge input for 5 second
- High operating temperature up to 70β
- Withstand 5G vibration test
- High efficiency, long life and high reliability
- 3 years warranty
Specifications
OUTPUT
- DC VOLTAGE
- 3.3V
- RATED CURRENT
- 3A
- CURRENT RANGE
- 0 ~ 3A
- RATED POWER
- 9.9W
- RIPPLE & NOISE (max.)Note.2
- 80mVp-p
- VOLTAGE ADJ. RANGE
- 2.9 ~ 3.6V
- VOLTAGE TOLERANCENote.3
- Β±3.0%
- LINE REGULATIONNote.4
- Β±0.5%
- LOAD REGULATIONNote.5
- Β±2.0%
- SETUP, RISE TIME
- 1000ms, 30ms/230VAC 1000ms, 30ms/115VAC at full load
- HOLD UP TIME (Typ.)
- 70ms/230VAC 12ms/115VAC at full load
INPUT
- VOLTAGE RANGE
- 85 ~ 264VAC 120 ~ 370VDC
- FREQUENCY RANGE
- 47 ~ 63Hz
- EFFICIENCY (Typ.)
- 72%
- AC CURRENT (Typ.)
- 0.35A/115VAC 0.25A/230VAC
- INRUSH CURRENT (Typ.)
- COLD START 65A / 230VAC
- LEAKAGE CURRENT
- <2mA / 240VAC
PROTECTION
- OVERLOAD
- Above 105% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed
- OVER VOLTAGE
- 3.8 ~ 4.45V Protection type : Shut off o/p voltage, clamping by zener diode
- OVER TEMPERATURE
- Shut down o/p voltage, recovers automatically after temperature goes down
ENVIRONMENT
- WORKING TEMP.
- -20 ~ +70β (Refer to "Derating Curve")
- WORKING HUMIDITY
- 20 ~ 90% RH non-condensing
- STORAGE TEMP., HUMIDITY
- -40 ~ +85β, 10 ~ 95% RH
- TEMP. COEFFICIENT
- Β±0.03%/β (0 ~ 50β)
- VIBRATION
- 10 ~ 500Hz, 5G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY & EMC (Note 6)
- SAFETY STANDARDS
- UL62368-1, TUV BS EN/EN62368-1 , AS/NZS 62368.1, EAC TP TC 004, CCC GB4943.1, BSMI CNS15598-1, BIS IS13252(Part1):2010/IEC 60950-1: 2005 approved
- WITHSTAND VOLTAGE
- I/P-O/P:3KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC
- ISOLATION RESISTANCE
- I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25β/ 70% RH
- EMC EMISSION
- Compliance to BS EN/EN55032 (CISPR32) Class B, BS EN/ EN61000-3-2,-3,GB9254 class B,GB17625.1, EAC TP TC 020, CNS15936 Class B
- EMC IMMUNITY
- Compliance to BS EN/EN61000-4-2, 3, 4, 5, 6, 8,11, BS EN/EN55035, BS EN/EN61000-6-1, light industry level, EAC TP TC 020
OTHERS
- MTBF
- 4914.9K hrs min. Telcordia SR-332 (Bellcore) ; 1608.9K hrs min. MIL-HDBK-217F (25β)
- DIMENSION
- 62.5*51*28mm (L*W*H)
- PACKING
- 0.13Kg; 108pcs/15Kg/0.8CUFT
Test conditions and notes7
- 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25β of ambient temperature.
- 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1ΞΌF & 47ΞΌF parallel capacitor.
- 3. Tolerance : includes set up tolerance, line regulation and load regulation.
- 4. Line regulation is measured from low line to high line at rated load.
- 5. Load regulation is measured from 0% to 100% rated load.
- 6. The power supply is considered a component which will be installed into a final equipment. All the EMC tests are been executed by mounting the unit on a 230mm*230mm metal plate with 1mm of thickness. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to βEMI testing of component power supplies.β (as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf )
- 7. The ambient temperature derating of 3.5β/1000m with fanless models and of 5β/1000m with fan models for operating altitude higher than 2000m(6500ft).
Technical drawings
Downloads
FAQ
Can I use the RS-15-3.3 for a 3.3V PLC or embedded control board?
Yes, this model is a constant-voltage 3.3V supply rated for up to 3A. That makes it suitable for 3.3V control electronics, embedded boards, and low-power automation circuits that stay within its 9.9W output rating.
Is the RS-15-3.3 a good fit for industrial sensors and logic-level electronics?
It can be a fit for 3.3V sensor hubs, logic circuits, and compact industrial electronics that need a regulated 3.3V output. Buyers should match the total load to the unit's 3A and 9.9W limits.
Can this power supply run a small embedded HMI or single-board controller that uses 3.3V power?
It is intended for low-power 3.3V equipment, so it can work for compact embedded controllers or interface boards that require constant-voltage 3.3V input. The key limit is available output current, which is 3A.
Is the RS-15-3.3 suitable for vibration-prone machine enclosures?
The specifications list 5G vibration (10-500Hz, X/Y/Z axes) and operation up to +70Β°C with derating per the derating curve. That makes it a reasonable option for protected industrial control enclosures where vibration resistance matters and the load stays within 9.9W.
Can the RS-15-3.3 be used outdoors or in hot equipment cabinets?
The operating temperature range is -20Β°C to +70Β°C, with output derating at higher ambient temperatures per the derating curve, so it is designed for a wide temperature span inside equipment. The provided specs do not list an IP rating, so it is better suited to protected indoor enclosures rather than exposed outdoor locations.
Payment & Security
Payment methods
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
Other RS-15 Models
5 other models| Model | Power | Voltage | Current | |
|---|---|---|---|---|
| Mean Well RS-15-24 Power Supply 15W 24V 625mA | 15W | 24V | 0.625A | View |
| Mean Well RS-15-5 Power Supply 15W 5V 3A | 15W | 5V | 3A | View |
| Mean Well RS-15-48 Power Supply 15W 48V 313mA | 15.024W | 48V | 0.313A | View |
| Mean Well RS-15-15 Power Supply 15W 15V 1A | 15W | 15V | 1A | View |
| Mean Well RS-15-12 Power Supply 15W 12V 1.3A | 15.6W | 12V | 1.3A | View |
Customer reviews
Reviewed by 14 customers across the RS series
-
Exactly as specced
Model: RS-15-24Quantity: 4Drop-in replacement, ran cool under full load on our DIN rail. Shipped same day.
-
Workhorse
Model: RS-50-24Quantity: 12Bought a dozen for a control panel build β every one perfect.
-
Solid little supply
Model: RS-100-24Quantity: 2Does the job. Wish the terminals were a touch bigger.
Please log in to write a review.
Write a review
Reviews are checked before publishing. By submitting you confirm this is your genuine experience with this product.
Submitting your reviewβ¦
It's published and now helps other buyers.
We're checking it and it'll appear shortly.
Please try again.







